Program Information
ArcCheck for Patient Specific QA in Stereotactic AblativeRadiotherapy
P Ramachandran*1,2,A Tajaldeen2,D Taylor1, D Wanigaratne1, Roozen K1,Esen N2, Geso M 2, Kron T1 (1)Peter MacCallum Cancer Centre, Melbourne, Australia (2)RMIT University, Bundoora, Australia
Presentations
SU-F-T-558 (Sunday, July 31, 2016) 3:00 PM - 6:00 PM Room: Exhibit Hall
Purpose: Stereotactic Ablative Radiotherapy (SABR) is one of the most preferred treatment techniques for early stage lung cancer. This technique has been extended to other treatment sites like Spine, Liver, Scapula, Sternum etc., This has resulted in increased physics QA time on machine. In this study, we've tested the feasibility of using ArcCheck as an alternative method to replace film dosimetry.
Methods: Twelve patients with varied diagnosis of Lung, Liver, scapula, sternum and Spine undergoing SABR were selected for this study. Pre-treatment QA was performed for all the patients which include ionization chamber and film dosimetry. The required gamma criteria for each SABR plan to pass QA and proceed to treatment is 95% (3%,1mm). In addition to this routine process, the treatment plans were exported on to an ArcCheck phantom. The planned and measured dose from the ArcCheck device were
compared using four different gamma criteria: 2%,2 mm, 3%,2 mm, 3%,1 mm and 3%, 3 mm. In addition to this, we've also introduced errors to gantry, collimator and couch angle to assess sensitivity of the ArcCheck with potential delivery errors.
Results: The ArcCheck mean passing rates for all twelve cases were 76.1%±9.7% for gamma criteria 3%,1 mm, 89.5%±5.3% for 2%,2 mm, 92.6%±4.2% for 3%,2 mm, and 97.6%±2.4% for 3%,3 mm gamma criteria. When SABR spine cases are excluded, we observe ArcCheck passing rates higher than 95% for all the studied cases with 3%, 3mm, and ArcCheck results in acceptable agreement with the film gamma results.
Conclusion:
Our ArcCheck results at 3%, 3 mm were found to correlate well with our non- SABR spine routine patient specific QA results (3%,1 mm). We observed significant reduction in QA time on using ArcCheck for SABR QA. This study shows that ArcCheck could replace film dosimetry for all sites except SABR spine.
Contact Email: